2010-03-05 Red Deer Audi S4 Wideband And Bearing
I had Concept1 change the noisy wheel bearing on my rear passenger. Then 2 days later I was driving to Red Deer to pickup and install my Innovate LC-1 Wideband and XD-16... When suddenly my rear driver side wheel started making an awful noise.
So, needless to say I needed another wheel bearing. Well I decided to do this one myself and safe the $400 in labour. I called NAPA on the drive, and they had one in stock. Sweeeeeeeet.
Every single bolt was seized! And I mean every bolt. And that's with pretty big impact guns. I was just trying to be careful not to strip any heads.
Then the silly ABS sensor wouldn't come out of the hub. So I cut the wires and soldered them back on later lol.
The Wideband went in pretty easy. I drilled and welded the bung next to one of the stock widebands on the downpipe. I ran the wires up through the same grommet as the boost gauge vacumn lines. I then mounted the gauge in the center vent. The boost gauge is on the driver side center vent. I will have to take a pic and post it in here when I remember.
|